e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedERROR CODE AND TROUBLESHOOTING6 - 36[E450] LCF side cover open jam1. Close the LCF side cover if it is opened. Remove if there is any paper before closing it.2. Is the LCF side cover opening/closing switch working? (Perform the input check: 03-[FAX]OFF/[0]/[D])3. Check if the connector CN349 on the LGC board is disconnected from the LCF side coveropening/closing switch or the harnesses are open circuited. Check if the connectors CN1 andCN6 on the LCF board are disconnected. Correct if any.4. Replace the LCF side cover opening/closing switch.5. Replace the LCF board.6. Replace the LGC board.[E480] Bridge unit open jam1. Close the bridge unit if it is opened. Remove if there is any paper before closing it.2. Is the bridge unit cover opening/closing detection switch working? (Perform the input check: 03-[FAX]OFF/[5]/[E])3. Check if the connector CN334 on the LGC board is disconnected from the bridge unit coveropening/closing detection switch or the harnesses are open circuited. Correct if any.4. Replace the bridge unit cover opening/closing detection switch.5. Replace the LGC board.[E4A0] Waste toner cover open jam1. Close the waste toner cover if it is opened. Remove if there is any paper before closing it.2. Is the waste toner cover open/close detection switch working? (Perform the input check: 03-[FAX]OFF/[1]/[H])3. Check if the connector CN359 on the LGC board is disconnected from the waste toner coveropen/close detection switch or the harnesses are open circuited. Correct if any.4. Replace the waste toner cover open/close detection switch.5. Replace the LGC board.
