6© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520CERROR CODE AND TROUBLESHOOTING6 - 117[ 7 ] E-mail reception related error[3A10] [3A11] [3A12] E-mail MIME errorThe format of the mail is not corresponding to MIME 1.0.Request the sender to retransmit the mail in the format corresponding to MIME 1.0.[3A20] [3A21] [3A22] E-mail analysis error[3B10] [3B11] [3B12] E-mail format error[3B40] [3B41] [3B42] E-mail decode errorThese errors occur when the mail data is damaged from the transmission to the reception of themail.Request the sender to retransmit the mail.[3A30] Partial mail time-out errorThe partial mail is not received in a specified period of time.Request the sender to retransmit the partial mail, or set the time-out period of the partial mail longer.[3A40] Partial mail related errorThe format of the partial mail is not corresponding to this equipment.Request the sender to remake and retransmit the partial mail in RFC2046 format.[3A50] [3A51] [3A52] Insufficient HDD capacity error[3A60] [3A61] [3A62] Warning of insufficient HDD capacityThese errors occur when the HDD capacity is not sufficient for a temporary concentration of thejobs, etc.Request the sender to retransmit after a certain period of time, or divide the mail into more than one.Insufficient HDD capacity error also occurs when printing is disabled for no printing paper.In this case, supply the printing paper.[3A70] Warning of partial mail interruptionThis error occurs when the partial mail reception setting becomes OFF during the partial mailreception.Reset the partial mail reception setting ON and then request the sender to retransmit the mail.[3A80] [3A81] [3A82] Partial mail reception setting OFFReset the partial mail reception setting ON and then request the sender to retransmit the mail.[3B20] [3B21] [3B22] Content-Type errorThe format of the attached file is not supported by this equipment (TIFF-FX).Request the sender to retransmit the file in TIFF-FX.[3B30] [3B31] [3B32] Charset errorThese errors occur when the standard of the Charset is other than ISO-8559-1 or ISO-8559-2.Request the sender to reformat the Charset into either of the standards described above and thenretransmit the mail.
