6© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520CERROR CODE AND TROUBLESHOOTING6 - 103[CD71] Waste transport motor drive locking errorIs the waste toner transport motor rotating? (Perform the output check: 03-415)|||||||||||ÈNO Æ 1. Check if the connector or the relay connector of the waste toner transportmotor is disconnected.2. Check if there is any damage or abnormality in the gears on the drivingcascade of the waste toner transport motor.3. Check if the connector CN342 on the LGC board is disconnected.4. Check if the connector pin is disconnected or the harness is broken.5. Check if the conductor pattern on the LGC board is short circuited or opencircuited.6. Replace the waste toner paddle motor.7. Replace the LGC board.YESIs the auger lock detection sensor operating normally? (Perform output check: 03-[FAX] ON/[2]/[G])||||||||||||ÈNO ÆTo judge it is an error, check if the sensor detects each status of normal displayand highlighted display.1. Check if the connector or the relay connector of the auger lock detectionsensor is disconnected.2. Check if the connector CN359 on the LGC board is disconnected.3. Check if the connector pin is disconnected or the harness is broken.4. Check if the conductor pattern on the LGC board is short circuited or opencircuited.5. Replace the auger lock detection sensor.6. Replace the LGC board.YES1. Check if the conductor pattern on the LGC board is short circuited or open circuited.2. Replace the LGC board.
