2 - NAV PAGES36 190-00356-00 Rev GMap Direct-ToTo designate an on-screen airport, navaid or userwaypoint as your direct-to destination:1. Use the panning function (see previous page)to place the target pointer on a waypoint.2. Press direct-to key to display the select direct-to waypoint page, with the selected waypointalready listed.3. Press ENT twice to confirm the selection andbegin navigating to the waypoint.The direct-to function can be used anywhere onthe map. If nothing currently exists at the crosshairposition, a new waypoint (called “+MAP”) will be cre-ated at the target pointer location before the direct-tois initiated.Airspace Information on the MapWhen a special-use or controlled airspace bound-ary appears on the map display, you can quicklyretrieve information — such as floor/ceiling limits andcontrolling agency — directly from the map.To view airspace information for an on-screenspecial-use or controlled airspace:1. Use the panning function (see previous page)to place the target pointer on an open areawithin the boundaries of an airspace. If thearea is congested and it is difficult to select anopen area, you may need to zoom in or pressCLR to make the selection easier.2. Press ENT to display an options menu.3. “Review Airspace?” should already be high-lighted, if not select it with the small rightknob. Press ENT to display the airspace infor-mation page for the selected airspace.To display airspace frequencies:1. While viewing the airspace information displayin the above example, turn the large rightknob to highlight “Frequencies?” and pressENT. Press CLR to return to the airspaceinformation page.2. Press CLR to exit the airspace informationpage. Press the small right knob (CRSR) toexit panning.Map Page
