7TAKEOFF TOUR190-00356-00 Rev GFuel On Board and ChecklistsThe instrument panel self-test page includes selec-tions to set fuel on board (FOB) to full capacity andaccess the checklists page. This allows you to quicklyset fuel to full limits and display any checklists you’veentered, such as start up or takeoff checklists.To set fuel on board to full (if not provided bysensor):1. Turn the large right knob to highlight “SetFull Fuel?”.Select “Set Full Fuel?” to set fuel on board(FOB) to full capacity.2. Press ENT and verify that fuel on board(“FOB”) now matches the fuel capacity (CAP)figure. Fuel on board will now be reduced, overtime, based on the fuel flow (FF) figure.Fuel On Board & ChecklistsTo view the checklists page:1. Turn the large right knob to highlight “Go ToChklist?” and press ENT.Select “Go To Chklist?” to display the check-list page and any available checklists. The400W-series unit can hold up to nine check-lists with up to 30 entries in each checklist.2. Turn the large right knob to select the desiredchecklist, then follow the steps in Section 9- Aux Pages - Utility Page to execute eachstep in the selected checklist.3. Once you complete the desired checklist(s),press the small right knob to return to thechecklists page. Press the small right knobagain to return to normal operation on thesatellite status or map pages.Once you’ve verified instrument operation withthe instrument panel self-test page displayed,press the ENT key.The satellite status page will appear as the 400W-series unit begins to collect satellite information. An“Acquiring” status will be displayed on the satellitestatus page, and the signal strength of any satellitesreceived will appear as “bar graph” readings. This isa good indication that you are receiving signals and aposition fix will be determined. Following the first-time use of your 400W-series unit, the time requiredfor a position fix will vary—within two minutes.
