2 - NAV PAGES32 190-00356-00 Rev GRestoring Factory SettingsYou can also quickly return all data field settings totheir original factory settings.To restore all six data fields to factory defaultsettings:1. Starting with the default NAV page, press theMENU key to display an options menu.2. Turn the large right knob to highlight the“Restore Defaults?” option and press ENT.Dual Unit ConsiderationsA “Crossfill?” option is provided from the DefaultNAV Page. This option allows you to transfer a direct-to destination, the active flight plan including VNAVparameters, any stored flight plan or user waypoints toa second 400W or 500W-series Garmin unit.See Section 9 - Aux Pages - Flight Planning -Crossfill Operation for additional details on using the“Crossfill?” option.NOTE: The databases of the 400/500 series andthe 400W/500W are incompatible so you may notmix systems.Map PageThe second NAV page is the map page, which dis-plays your present position using an airplane symbol,along with nearby airports, navaids, user-definedwaypoints, airspace boundaries, lakes, rivers, high-ways and cities.NOTE: The electronic chart is an aid to navigationand is designed to facilitate the use of authorizedgovernment charts, not replace them. Land andwater data is provided only as a general referenceto your surroundings. The positional accuracyof the land and water data is not of a precisionsuitable for use in navigation and it should notbe used for navigation. Only ofifcial governmentcharts and notices contain all information neededfor safe navigation – and, as always, the user isresponsible for their prudent use.DataFieldsPresentPositionMap DisplayMap RangePage locationin NAV groupNOTE: If the 400W-series unit is unable todetermine a GPS position, the present position(airplane) symbol will appear on the Map Page inyellow. No symbol will be present when there isno active flight plan.Map Page
