6 - WPT PAGES133190-00356-00 Rev GCreating User Waypointswaypoints which are generated from otherequipment in your panel. For example, an EFISequipped with joystick inputs can be used tocreate user waypoints which will (if your installa-tion supports this) automatically transfer to your400W-series unit.Creating User Waypoints from the Map PageThe map page and panning target pointer provide aquick means of saving your present position as a user-defined waypoint.To capture and save your present position as auser waypoint:1. With the map page displayed, press the smallright knob to activate the panning function.The target pointer will appear at your presentposition.2. Press ENT to capture the position and displaythe user waypoint page.3. A four-digit name is automatically assigned tothe waypoint. To change this name, turn thelarge right knob to highlight the name field,then use the small and large right knobs toselect a new name. Press ENT to accept theselected name.4. The cursor moves to the “Create?” action field.Press ENT to save the new waypoint.Modifying User WaypointsTo modify an existing waypoint, select thatwaypoint on the user waypoint page and enter the newposition information directly over the old information.To modify a user waypoint by changing its lati-tude/longitude position:1. With the user waypoint page displayed, pressthe small right knob to activate the cursor.2. Use the small and large right knobs to enterthe name of the desired waypoint and pressENT.3. Turn the large right knob to highlight theposition field at the bottom of the page.4. Use the small and large right knobs to enterthe new position coordinates and press ENTto accept the selected position.5. The cursor moves to the “Modify?” action field.Press ENT to modify the waypoint.6. Press the small right knob to remove theflashing cursor.To modify a user waypoint by changing referencewaypoint information:1. With the user waypoint page displayed, pressthe small right knob to activate the cursor.2. Use the small and large right knobs to enter thename of the desired waypoint and press ENT.
