17TAKEOFF TOUR190-00356-00 Rev GIFR ProceduresIFR ProceduresOnce the direct-to or flight plan is confirmed, thewhole range of instrument procedures is available toyou. Departures (SIDs), arrivals (STARs), non-preci-sion and precision approaches are stored within theNavData card and available using the PROC (proce-dures) key.To display the procedures page, press PROC.The steps required to select and activate anapproach, departure or arrival are identical. In thisintroductory section, we’ll show examples of the stepsrequired to select an approach, but keep in mind thesame process also applies to departures and arrivals.To select an approach, departure, or arrival:1. Turn the small right knob to select the desiredoption (“Select Approach?”, “Select Arrival?”or “Select Departure?”) from the procedurespage.Press the PROC key to display the procedurespage. Turn the large right knob to select thedesired option.2. Press ENT to display a list of available proce-dures for the arrival (when using approachesor STARs) or departure (when using SIDs)airport.3. Turn the small right knob to select the desiredprocedure and press ENT.4. For approaches, a window appears to select thedesired initial approach fix (IAF) or provide a“vectors” option to select just the final coursesegment of the approach. Turn the small rightknob to select the desired option and pressENT. Vectors guidance is relative to the finalinbound course. A line is drawn beyond thefinal approach fix, allowing you to interceptthe final course segment beyond its normallimits.A window will appear to select the desiredprocedure. Use the large right knob to makeyour selection.5. For departures and arrivals, a window appearsto select the desired transition. Turn the smallright knob to select the desired option andpress ENT.6. With “Load?” highlighted, press ENT to addthe procedure to the flight plan or direct-to.In your flight plan or direct-to, the departureor arrival airport is replaced with the sequence ofwaypoints contained within the selected procedure.