Configuring the Network AddressPhaser® 6180MFP Multifunction Printer4-7Dynamic Methods of Setting the Printer’s IP AddressThere are two protocols available for dynamically setting the printer’s IP address:■ DHCP (enabled by default on all Phaser printers)■ AutoIPYou can turn on/off both protocols using the control panel, or use CentreWare IS to turn on/offDHCP.Note: You can print a report that includes the printer’s IP address. On the control panel, pressthe System button, select Information Pages, press the OK button, select Configuration, andthen press the OK button. The IP address is listed on the Configuration report.Using the Control PanelTo turn on/off either the DHCP or AutoIP protocol:1. On the control panel, press the System button.2. Select the Admin menu, and then press the OK button.3. Select the Network Settings menu, and then press the OK button.4. Select the TCP/IP menu, and then press the OK button.5. Select Get IP Address, and then press the OK button.Using CentreWare ISTo turn on/off the DHCP protocol:1. Launch your web browser.2. Enter the printer’s IP address in the browser’s Address field.3. Select Properties.4. Select the Protocols folder on the left navigation panel.5. Select TCP/IP.6. In the Get IP Address field, select the DHCP/Autonet option.7. Click the Save Changes button.
