Control Panel Error MessagesPhaser® 6180MFP Multifunction Printer10-34Messages About the Printer and Other ItemsMessage Condition/Reason/Action042-700Over HeatThe printer’s internal temperature is too high.The printer has been stopped. Wait 1 hour before restarting theprinter. Ensure the printer has adequate cooling space around it,and that the cooling vents are not blocked.077-912Push in Tray 2Tray 2 is pulled out.Push Tray 2 into the correct position.Controller ErrorError 116-397 and -398Restart PrinterAn internal controller error occurred.Restart the printer.Disabled FuncPress OKThe function that you are trying to access has been disabled.Enable the function through the control panel menus, or contactyour printer administrator. See Using the Control Panel Menusand Keypad on page 9-1.Door A OpenClose Door AThe front cover is open.Close the front cover.Fan Motor ErrorError 042-3NNRestart PrinterAn error has occurred with the fan.Restart the printer. If the problem persists, contact XeroxTechnical Support.Fuser ErrorError 010-397Error Code: xxRestart PrinterA fuser error has occurred.Restart the printer. If the problem persists, contact XeroxTechnical Support.Invalid FeaturePress OKThe user is not registered to print in color when using anauthentication function.Contact your administrator.Invalid JobPress OKWhen the configuration of the printer on the print driver does notconform to the printer you are using, this message appears.Press the Stop button to cancel the print job.Make sure that the configuration of the printer on the print driverconforms to the printer you are using.Invalid UserPress OKThe user is not registered to print on the printer when using anauthentication function.Contact the administrator.Jam at Tray 1Check Tray 1Open Door APaper is jammed inside Tray 1 (MPT).Remove the jammed paper. Open and close the front cover. SeePaper Jams on page 10-2.
