Overview of Network Setup and ConfigurationPhaser® 6180MFP Multifunction Printer4-2Overview of Network Setup and ConfigurationTo set up and configure the network:1. Connect the printer to the network using the recommended hardware and cables.2. Turn on the printer and the computer.3. Print the Configuration page and keep it for referencing network settings. For moreinformation see Displaying Optional Accessory Configuration and Paper Tray Settings onpage 2-12.4. Install the driver software on the computer from the Software and DocumentationCD-ROM. For information on driver installation, see the section in this chapter for thespecific operating system you are using.5. Configure the printer’s TCP/IP address, which is required to identify the printer on thenetwork.■ Windows operating systems: Run the Installer on the Software and DocumentationCD-ROM to automatically set the printer’s IP address if the printer is connected to anestablished TCP/IP network. You can also manually set the printer’s IP address on thecontrol panel.■ Macintosh systems: Manually set the printer’s TCP/IP address on the control panel.6. Print a Configuration page to verify the new settings.Note: If the Software and Documentation CD-ROM is not available, you can download thelatest driver from www.xerox.com/office/6180MFPdrivers.
