Adjusting Copying OptionsPhaser® 6180MFP Multifunction Printer6-12Output AdjustmentsYou can change the following output adjustment settings:■ Collating Copies on page 6-12■ Output Quality on page 6-12Collating CopiesWhen you make several copies of a multi-page document, you can collate the output. Forexample, if you are making three single-sided copies of a six-page document, the copies areprinted in this order when you select collated:1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6If you select uncollated, the copies are printed in this order:1, 1, 1, 2, 2, 2, 3, 3, 3, 4, 4, 4, 5, 5, 5, 6, 6, 6To select a collating option:1. On the control panel, press the Copy button.2. Select Collated, and then press the OK button.3. Select Uncollated or Collated, and then press the OK button.Note: The factory default is Uncollated.Output QualityThe following table describes the two output-quality modes:To change the output-quality mode:1. On the control panel, press the Copy button.2. Select Output Quality, and then press the OK button.3. Select either Standard or Enhanced, and then press the OK button.Note: The factory default is Standard.Output-Quality Mode Type of Copy JobStandard General-purpose mode for copies. Produces crisp,bright copies at high speed.Enhanced Best mode for high quality copies. Produces verysmooth accurate colors. This mode takes longer toprocess and print than Standard mode.
