Choosing a Connection MethodPhaser® 6180MFP Multifunction Printer4-3Choosing a Connection MethodConnect the printer via Ethernet, USB, or parallel. A USB or a parallel connection is a directconnection and is not used for networking. An Ethernet connection is used for networking.Hardware and cabling requirements vary for the different connection methods. Cabling andhardware are generally not included with your printer and must be purchased separately. Thissection includes:■ Connecting via Ethernet and USB on page 4-3■ Connecting via Ethernet on page 4-3■ Connecting via USB on page 4-4■ Connecting via Parallel on page 4-5Connecting via Ethernet and USBYou can connect your Phaser 6180MFP printer through Ethernet, USB, or both at the sametime. The available features for each connection type are shown in the following table.For information on each connection type, see Connecting via Ethernet on page 4-3 andConnecting via USB on page 4-4.Connecting via EthernetEthernet can be used for one or more computers. It supports many printers and systems on anEthernet network. An Ethernet connection is recommended because it is faster than a USBconnection. It also allows you direct access to CentreWare Internet Services (IS). TheCentreWare IS web interface enables you to manage, configure, and monitor networkedprinters from your desktop.Connection Type Available FeaturesUSB When connected via USB you can:■ Scan an image into an application.■ Scan an image to a folder on the computer.■ Use the Address Book Editor to manage address book entries.Ethernet When connected via Ethernet you can:■ Scan to a computer on the network.■ Scan to an FTP server.■ Scan to email.■ Use CentreWare IS to manage address book entries.
