Printing Custom Size or Long PaperPhaser® 6180MFP Multifunction Printer5-426. Specify the length of the short edge and long edge under Settings for. You can specify thevalues either by entering them directly or using the Up Arrow and Down Arrow buttons.The length of the short edge cannot be longer than the long edge, even if it is within thespecified range. The length of the long edge cannot be shorter than the short edge, even ifit is within the specified range.7. To assign a paper name, select the Name Paper Size check box, and then enter the namein Paper Name. Up to 14 characters can be used for the paper name.8. If necessary, repeat steps 4 to 6 to define another custom size.9. Click OK twice.Using the PostScript DriverOn the PostScript print driver, set the custom size in the Custom Paper Size dialog box. Thissection explains the procedure using Windows XP as an example.1. From the Start menu, select Settings, click Printers and Faxes, and then display theproperties of the printer to be used.2. Select the General tab.3. Click the Printing Preferences button.4. Select the Paper/Output tab.5. From Paper Size, select Custom Page Size.6. Specify the length of the short edge and long edge under Custom Size Settings. Thelength of the short edge cannot be longer than the long edge, even if it is within thespecified range. The length of the long edge cannot be shorter than the short edge, even ifit is within the specified range.7. Click OK.Printing on Custom Size PaperUse the following procedures to print using either the PCL or PostScript drivers.Using the PCL DriverTo print on custom size paper using the PCL print driver:Note: The way to display the printer Properties dialog box differs according to theapplication software. Refer to the manual of your respective application software.1. From the File menu, select Print.2. Select the printer as the printer to be used and click Preferences.3. Select the Paper/Output tab.4. Select the appropriate paper tray from Paper Tray.5. Select the appropriate paper type from Paper Type. This selection is only available if thepaper tray is set to Auto Select or Tray 1 (MPT).6. From Paper Size, select the size of the original document.7. Click the Layout tab.
