User SafetyPhaser® 6180MFP Multifunction Printer1-4Maintenance Safety■ Do not attempt any maintenance procedure that is not specifically described in thedocumentation supplied with your printer.■ Do not use aerosol cleaners. The use of supplies that are not approved may cause poorperformance and could create a hazardous condition.■ Do not attempt to open, reuse, or burn any consumables or routine maintenance items. Forinformation on Xerox supplies recycling programs, go to www.xerox.com/gwa.Operational SafetyYour printer and supplies were designed and tested to meet strict safety requirements. Theseinclude safety agency examination, approval, and compliance with established environmentalstandards.Your attention to the following safety guidelines helps to ensure the continued, safeoperation of your printer.Printer LocationPlace the printer in a dust-free area within a temperature range of 50° F to 95° F (10° C to35° C) and a relative humidity range of 15 percent to 80 percent.Note: Sudden temperature fluctuations can affect print quality. Rapid heating of a cold roomcan cause condensation inside the machine, directly interfering with image transfer.Printer ClearancePlace the printer in an area where there is adequate space for ventilation, operation, andservicing. The recommended minimal spacing is:Overhead Clearance:■ 35 cm (13.8 in.) above the printerTotal Height Requirements:■ 108 cm (42.5 in.)Other Clearances:■ 10 cm (3.9 in.) behind the printer■ 60 cm (23.6 in.) in front of the printer■ 10 cm (3.9 in.) on the left side of the printer■ 10 cm (3.9 in.) on the right side of the printer
