Problems With the PrinterPhaser® 6180MFP Multifunction Printer10-30Condensation hasoccurred inside theprinterTurn the printer on, and leave it on, for at least one hour to get rid of thecondensation. If the problem continues, refer to the Xerox Support website,www.xerox.com/office/6180MFPsupport.Paper cannot be fed.Paper jams.Multiple paper are fed.Paper is fed at anangle.Paper is wrinkled.Is the paper correctly loaded?Load the paper correctly. For labels, transparencies, or envelopes, fanthem well to allow air to enter between each sheet before loading. SeeLoading Paper in Trays 2 and 3 on page 5-13.Is the paper damp?Replace with paper from a new ream. See Loading Paper in Trays 2 and 3on page 5-13.The paper used is not suitable.Load the correct type of paper. See About Paper on page 5-6.Is the paper tray set correctly?Push the paper tray completely into the printer.Is the printer placed on a flat location?Place the printer on a stable flat surface.Are the paper tray guides set in the correct positions?Set the guides to the correct positions. See Loading Paper in Trays 2 and 3on page 5-13.Paper is fed more than 1 sheet at a time.Multiple feeding of paper may occur before the sheets of paper loaded inthe tray are used up. Remove the paper, fan it, and load again. Replenishpaper only when all the sheets of the loaded paper are used up.Unusual noises The printer is not level.Reposition the printer on a flat, stable surface.The paper tray is not inserted properly.Push the paper tray completely into the printer.There is a foreign object inside the printer.Turn off the printer and remove the foreign object. Refer to the XeroxSupport website, www.xerox.com/office/6180MFPsupport, for assistance.Symptom Reason/Action
