64 Keysight N9923-90001 User’s GuideTime Domain – Option 010Time Domain (Transform) SettingsTime Domain (Transform) SettingsYou can set and view most of the Time Domain settings on the TransformSettings table.Transform Settings TableThe following settings (from Transform Stimulus Settings to Data Processing)are listed in the order they appear on the Transform Settings menu selection.How to make settings on the Transform settings table— Press Meas Setup 4.— Then Transform— Then Transform Settings.— Press Next Page and Previous Page to view all settings.— Tochangeasetting:—Use the arrows or rotary knob to highlight a setting.—Numeric settings can be changed by pressing numbers using thenumeric keypad. Then press Enter or select a suffix if available.—Some settings allow you to press Ed it to toggle the value. Othersettings require that you then press a softkey to change the value.—When finished changing a value, press Done Edit.— Press Dock Window to relocate the Settings table to a position relative tothe trace window. The Dock Window setting persists through a Preset.Choose from the following:—Full (Default setting) Only the Settings table is shown on the screen.The trace window is temporarily not shown.—Left The Settings table is shown to the left of the trace window.—Bottom The Settings table is shown below the trace window.— When finished changing ALL settings, press Done to save your settings.Frequency Range and PointsLike CAT mode, all Time Domain measurements are made in the frequencydomain and, using Inverse Fourier Transform (IFT), time is calculated. Selectthe frequency range from which Time Domain measurements are calculated.Increasing the data points will improve measurement resolution. However,more data points will usually result in slower sweep updates.Set frequency range and points before selecting Stimulus Mode.
