132 Keysig ht N9923-90001 User’s GuidePower Meter (USB) ModeUSB Power Meter SettingsResolutionResolution sets the number of digits to display after the decimal point on thedigital power meter display.How to set Resolution— Press Scale / Amptd.— Then More.— Then,in Resolution, choose from 0, 1, 2, or 3.AveragingAveraging is used to improve measurement accuracy in low power or noisypower situations. Increased averaging improves measurement accuracy, butalso reduces measurement speed.How to set Power Meter Averaging— Press BW 2 or Meas Setup 4.— Then choose from the following:— Averaging Auto Man Off— Auto Allows the USB Power Sensor to use its Auto Averagingsettings. See the USB Power Sensor documentation for details.— Man Manually enter an averaging count by setting Num Averages.— OFF Performs NO averaging.— Num Averages Sets the number of Power Meter readings to beaveraged before a valid reading is displayed. When the number ischanged, Averaging is automatically set to Man.Single or Continuous MeasureThis setting determines whether the FieldFox measures continuously or onlyonce each time the Single button is pressed. Use Single to conserve batterypower or to allow you to save or analyze a specific measurement.This setting can be changed at any time without affecting calibration accuracy.How to set Single or Continuous— Press Sweep 3.— Then choose one of the following:
