192 Keysig ht N9923-90001 User’s GuideFile ManagementSaving and Recalling FilesSaving and Recalling FilesThe FieldFox model families are:— N991x (VNA/SA) model family— N992x (VNA) model family— N993x (SA) model family— N995x (VNA/SA) model family— N996x (SA) model familySave FilesHow to Save a File— Press Save/Recall 9— Then Save— At the top of the current ‘labeler’ screen (see following image) check theFile Type to save and Device (Internal, USB, Storage Card) to which the fileis saved. Learn how to change these settings in “Set File Type and SelectDevice” on page 196.— Then use the labeler to specify a filename.FieldFox State files are intended to be recalled on the same instrumentmodel on which they were saved. Sometimes you may able to recall themwithin model families. An error will result when trying to recall a state filethat was saved on a different model family.If you are having difficulty saving to a USB flash drive, it may be a timing issue.The turn-around time for “file open, write data, file close” to a USB drive is muchlonger than to FieldFox’s internal memory. Alternative methods are:1. Save your content to the FieldFox’s internal memory; and then move your filesoff to a USB flash drive using FTP SCPI programming. Refer to Using FTP withFieldFox and to the FieldFox Programming Guide.2. Save your data to the FieldFox’s internal memory, then move the data to a PCusing a binary block transfer, and delete the data from the FieldFox’s internalmemory. An example for transferring an image:http://na.support.keysight.com/fieldfox/help/Programming/webhelp/Examples/Transfer_Image_to_PC.htm. Please note that the receivingcomputer program needs to be able to handle the binary block transfer. Seealso FieldFox Programming Guide .
