232 Keysig ht N9923-90001 User’s GuideSystem SettingsPower ON—DHCP - IP Address is assigned dynamica lly. If your server supports thisfeature, the IP Address for the FieldFox is assigned each time it isstarted.—Static - Set the IP Address manually. The Address remains until youchange it.— Static IP Address - Enter the IP Address – including periods - in the formatnnn.nnn.nnn.nnn— Static Subnet Mask - Enter the Subnet Mask – including periods - in theformat nnn.nnn.nnn.nnn— Static Gateway - Enter the Static Gateway – including periods - in theformat nnn.nnn.nnn.nnn— Apply Settings Choose from:—Power Up The above settings take effect when the FieldFox is started.—Now The above settings take effect immediately.— Press Done Ed it when finished.Power ONWhen the FieldFox is without a power source, this setting allows the FieldFoxto power ON as soon as a charged battery or the DC Adapter is insertedwithout pressing the power button.How to set Power ON— Press System 7.— Then System Configuration.— Then Power ON.— Then choose from the following:— Auto The FieldFox will power ON when a charged battery or the DCAdapter is inserted.— Manual The FieldFox will power ON only when the power button ispressed.To make the LAN settings persist after power up, toggle Apply Settings toNow then back to Power Up. You should see a message indicating that theLAN config file was saved.
