230 Keysig ht N9923-90001 User’s GuideSystem SettingsSystem Configuration— Static IP Address - Enter the IP Address – including periods - in theformat nnn.nnn.nnn.nnn— Static Subnet Mask - Enter the Subnet Mask – including periods - in theformat nnn.nnn.nnn.nnn— Static Gateway - Enter the Static Gateway – including periods - in theformat nnn.nnn.nnn.nnn— Static DNS - Enter the Static DNS – including periods - in the formatnnn.nnn.nnn.nnn6— Apply Settings Choose from:—Power Up The above settings take effect when the FieldFox is started.—Now The above settings take effect immediately.— Press Done Ed it when finished.Power ONWhen the FieldFox is without a power source, this setting allows the FieldFoxto power ON as soon as a charged battery or the DC Adapter is insertedwithout pressing the power button.How to set Power ON— Press System 7— Then System Configuration— Then More— Then Power ON— Then choose from the following:—Auto The FieldFox will power ON when a charged battery or the DCAdapter is inserted.—Manual The FieldFox will power ON only when the power button ispressed.For all A.08.15 and A.09.15 FW and above, when using Static IP addresses:— Either a valid Static Gateway is required or 0.0.0.0.— Either a valid Static DNS is required or 0.0.0.0.To make the LAN settings persist after power up, toggle Apply Settings toNow then back to Power Up. You should see a message indicating that theLAN config file was saved.
