Keysight N9923-90001 User’s Guide45NA (Network Analyzer) ModeNA Mode SettingsQuick SettingsBoth CAT and NA Modes allow you to view and change most relevant settingsfrom a single location. All of these settings are discussed in this chapter and,unless otherwise noted, ALL of these settings can also be made using thestandard softkey menus. In the graphic below, the resolution is being edited.How to view and change Quick Settings— Press Meas Setup 4— Then Settings.— Press Next Page and Previous Page to view all settings. If these softkeysare NOT available, then all available settings fit on one page.— Tochangeasetting:—Use the arrows to highlight a setting.—Then press Ed it. The current setting changes to yellow.—Some settings require you to press a softkey to change the value.Otherwise, use the numeric keypad, arrows, or rotary knob tochange the value.—When finished changing a value, press Done Edit.— Press Dock Window to relocate the Settings table to a position relative tothe trace window. The Dock Window setting persists through a Preset.Choose from the following:Interference Rejection and System Z0 can be changed ONLY from theQuick Settings menu. Learn more about these settings in “SystemImpedance (Z0)” on page 54. ALL other settings can also be made usingthe standard softkey menus.
