148 Keysig ht N9923-90001 User’s GuidePulse Measurements Mode – Option 330Pulse Measurement SettingsPulse Measurement SettingsSelect Pulse Measurement Mode before making any setting in this section.How to select Pulse Measurement Mode— Press Mode— Then More if your FieldFox contains more than five measurement modes.— Then Pulse MeasurementsMeasurement SelectionThe pulse measurement results are presented as either a traditional powermeter display or as a trace graph.How to select the Measurement— Press Measure 1— Then choose from the following:— Average Average power (Meter display)— Peak Peak power (Meter display)— Pk to Avg Displays the difference between the above twomeasurements (Meter display)— Trace Graph (default) The primary trace (Tr 1) plots pulse data inamplitude versus time. Optionally, you can enable a secondary‘zoom’ trace. Learn how in “Zoom Window” on page 149.When a ‘Meter display’ measurement is selected, the following PulseMeasurement Mode settings are identical to the standard USB PowerMeter Mode settings.— Learn how to set Scale in “Scale” on page 150.— Learn how to set Relative and Offset Power in “Relative and OffsetPower Measurements” on page 131.— Learn how to set Display Units in“Display Units” on page 131.— Learn how to set Limits in “All about Limit Lines” on page 185.Frequency / TimeHow to set Frequency— Press Freq/Dist— Then choose from the following:
