46 Keysight N9923-90001 User’s GuideNA (Network Analyzer) ModeNA Mode Settings—Full (Default setting) Only the Settings table is shown on the screen.The trace window is temporarily not shown.—Left The Settings table is shown to the left of the trace window.—Bottom The Settings table is shown below the trace window.When finished changing ALL settings, press Done to save your settings.Calibration SettingsNA Mode has a page specifically for making settings that pertain to PortExtensions, including Velocity Factor and Media Type.Learn more in “Port Extensions” on page 54.Learn more about Media Type in “Waveguide Calibrations” on page 117.How to view and change Calibration Settings— Press Meas Setup 4.— Then Calibration Settings— Make these settings in the same manner as Quick Settings in the previoussection.FormatSelect the display format in which to pr esent measurement results. This settingcan be changed at any time without affecting calibration accuracy.The marker on-screen readout can be changed to formats other than thedisplay format. Learn more in “Marker Format” on page 178.How to select a NA Format— Press Measure 1.— Then Format [current setting].— Then choose from the following:—Log Magnitude Displays magnitude in dB—Linear Displays positive values only. Y-axis: Unitless (U) for ratioedmeasurements; Watts (W) for unratioed measurements.—VSWR Used mainly for S11 and S22. Displays unitless reflection data.—Phase Displays phase in degrees. The trace ‘wraps’ every 360 degrees,from +180 to –180, for easy scaling.Learn more about Display Formats in the FieldFox Supplemental OnlineHelp:http://na.support.keysight.com/fieldfox/help/SupHelp/FieldFox.htm
