9 - AUX PAGES172 190-00356-00 Rev BCOM Configuration— allows you to select 8.33kHz or 25.0 kHz COM frequency channel spacing.NOTE: 8.33 kHz VHF communication frequencychannel spacing is not approved for use in theUnited States. Select the 25.0 kHz channel spac-ing option.To set the COM channel spacing:1. Select “COM Configuraton” and press ENT.2. Turn the small right knob to select “8.33 kHz”or “25.0 kHz” and press ENT.Preset Com FrequenciesOn units configured for COM Frequency Presetsyou may store up to 15 preset Com frequencies in theCom Configuration page. On units configured with aremote Com frequency recall switch, these preset fre-quencies can be loaded into the STBY frequency withthe press of a button.NOTE: Preset Com Frequencies are only availablewith SW Version 3.00, or later.To store a preset Com frequency:1. Select “COM Configuraton” from the Setup 2Page.2. The flashng cursor wll hghlght the ChannelSpacng field. Turn the large right knob tohghlght the left (non-decmal) part of the firstfrequency field.3. Turn the small right knob to select the desredfrequency.4. Turn the large right knob to hghlght therght (decmal) part of the frequency field.5. Turn the small right knob to enter the desredfrequency.6. Repeat for any remanng desred frequences,then press the small right knob to finsh.When the remote Com frequency recall switch ispressed, the next preset frequency will be moved into theCom Standby frequency box and a small window with thecurrent Com Frequency Preset number will appear nextto it. You can scroll down through the preset frequenciesby repeatedly pressing the remote Com Frequency recallswitch. Empty Preset slots are skipped.DisplayTo change the backlighting intensity:1. Select “Dsplay” from the Setup 2 page.Setup 2
