August 20072-648 WorkCentre 5687 Family11C-171Status Indicator RAPs11C-171 HVF BM Bin 2 Failure RAPBin 2 fails to remove the finished booklets from the exit area of the booklet maker.Initial ActionsWARNINGSwitch off the electricity to the machine, GP 14. Disconnect the power cord from thecustomer supply while performing tasks that do not need electricity. Electricity cancause death or injury. Moving parts can cause injury.Check for a jam or any other obstruction that could prevent the conveyor belt mechanism frommoving.ProcedureEnter dC330 code 11-389. Actuate the BM bin 2 90% full sensor, Q11-389, Figure 1. The dis-play changes.Y NIf a tri-folder is installed, go to Flag 4. Check the connection at PJ583 on the tri-folder.The connection are good.Y NCheck the connectors and harness at the tri-folder. Repair the harness as neces-sary, REP 1.2.Go to Flag 1. Check Q11-389.Refer to:• GP 11, How to Check a Sensor.• P/J556, BM PWB.• 11A-171 HVF BM Power Distribution RAP.Install new components as necessary:• BM PWB, PL 11.166 Item 10.• BM bin 2 90% full sensor PL 11.169 Item 5.NOTE: The BM conveyor belts drive motor stops after 10 seconds.Enter dC330, code 11-402 to run the BM conveyor belts drive motor, MOT11-402. MOT11-402runs.Y NIf a tri-folder is installed, go to Flag 5. Check the connection at PJ583 on the tri-folder.The connection are good.Y NCheck the connectors and harness at the tri-folder. Repair the harness as neces-sary, REP 1.2.Go to Flag 3 or Flag 2. Check MOT 11-402.Refer to:• GP 10 How to Check a Motor.• P/J555, BM PWB.• 11A-171 HVF BM Power Distribution RAP.Install new components as necessary:• BM conveyor belts drive motor, PL 11.169 Item 4.• BM PWB, PL 11.166 Item 10.The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.2. If neces-sary install new conveyor belts, PL 11.169 Item 1.Figure 1 Component locationBM bin 2 90% fullsensor Q11-389 BM conveyor belts drivemotor, MOT11-402AA
