August 20072-384 WorkCentre 5687 Family11-030-130, 11-336-130Status Indicator RAPs11-030-130, 11-336-130 Bin 1 Movement Failure RAP11-030-130 Bin 1 fails to move.11-336-130 Bin 1 is not at the home position.NOTE: The home position is at the uppermost position.Initial Actions• Check that bin 1 is not damaged and there are no obstructions that would prevent bin 1from moving. If necessary, install a new bin 1, PL 11.52 Item 4.• Press the manual staple button, PL 11.32 Item 10 to lower bin 1. Press again the manualstaple button to raise bin 1.ProcedureNOTE: All HCSS interlocks must be made to supply +24V to the motors.Enter dC330, codes 11-032 bin 1 elevator motor down to run the bin 1 elevator motor, MOT11-030, Figure 1. MOT11-030 runs.Y NGo to Flag 2. Check MOT11-030.Refer to:• GP 10, How to Check a Motor.• P/J424, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary:• Bin 1 elevator motor, PL 11.52 Item 11.• HCSS PWB, PL 11.56 Item 5.Enter dC330, codes 11-032 bin 1 elevator motor down, then 11-030 bin 1 elevator motor homeFigure 1. Bin 1 moves away from, then back to, the home position.Y NCheck the bin 1 front and rear elevator belts:• Ensure that both belts are correctly positioned on the upper and lower pulleys.• Ensure that bin 1 is securely clamped to both elevator belts.Enter dC330, code 11-334, actuate the bin 1 upper limit switch, S11-334, Figure 1. The dis-play changes.Y NGo to Flag 3. Check the switch S11-334.Refer to:• GP 13, How to Check a Switch.• P/J424, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary.• Bin 1 upper limit switch, PL 11.52 Item 1.• HCSS PWB, PL 11.56 Item 5.Enter dC330, code 11-335, actuate the bin 1 lower limit switch, S11-335, Figure 1. The dis-play changes.Y NGo to Flag 4. Check the switch S11-335.Refer to:• GP 13, How to Check a Switch.• P/J424, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary.• Bin 1 lower limit switch, PL 11.52 Item 2.• HCSS PWB, PL 11.56 Item 5.Enter dC330, code 11-035, actuate the bin 1 empty sensor, Q11-035, Figure 1. The displaychanges.Y NGo to Flag 1. Check the sensor Q11-035.Refer to:• GP 11, How to Check a Sensor.• P/J416, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary:• Bin 1 empty sensor, PL 11.52 Item 5.• HCSS PWB, PL 11.56 Item 5.Perform SCP 6 Final Actions.AA
