August 20072-516 WorkCentre 5687 Family11-415-170Status Indicator RAPs11-415-170 HCSS BM Crease Roll Gate Failure RAP11-415-170 The HCSS crease roll gate is not at the home position.Initial Actions• Check for a jam or other obstruction that can prevent the crease roll gate mechanism frommoving.• Check the following parts for damage:– Crease roll gate rack gears, PL 11.87 Item 8.– Crease roll gate racks, PL 11.87 Item 14.ProcedureEnter dC330 code 11-415. Actuate the BM crease roll gate home sensor, Q11-415. The dis-play changes.Y NGo to Flag 1, check the BM crease roll gate home sensor, Q11-415, Figure 1.Refer to:• GP 11, How to Check a Sensor.• P/J552, BM PWB.• 11C-170 HCSS BM Power Distribution RAP.Install new components as necessary:• BM PWB, PL 11.86 Item 10.• BM crease roll gate home sensor PL 11.86 Item 9.Enter dC330, code 11-401 to run the BM crease roll gate motor, MOT 11-401, Figure 1. Themotor runs.Y NGo to Flag 2 and Flag 3, check the BM crease roll gate motor, MOT 11-401.Refer to:• GP 10 How to Check a Motor.• P/J555, BM PWB.• 11C-170 HCSS BM Power Distribution RAP.Install new components as necessary:• BM PWB, PL 11.86 Item 10.• BM crease roll gate motor, PL 11.86 Item 8.The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.2. If neces-sary install a new BM PWB, PL 11.86 Item 10.Figure 1 Component locationBM crease roll gate home sensor,Q11-415BM crease roll gate motor,MOT 11-401
