August 20072-327WorkCentre 5687 Family 11C-110Status Indicator RAPs11C-110 2K LCSS Initialization Failure RAPWhen an initialization command is received from the machine, the units are initialized in twostages:• The following units are initialized sequentially:1. If the staple head is not at the home position, it is driven to the home position2. If the stapling unit is not at the home position, it is driven to the home position3. If the ejector is not at the home position, it is driven to the home position• The following units are then initialized simultaneously:1. If the front tamper is not at the home position, it is driven to the home position2. If the rear tamper is not at the home position, it is driven to the home position3. If the hole punch is not at the home position, it is driven to the home position4. If the paddle is not at the home position, it is driven to the home position5. If the stacker is not at the home position, it is driven to the home positionNOTE: The staple cartridge must be fully pushed home.WARNINGTake care not to topple the LCSS.The LCSS is unstable when un-docked from the machine.Do not show the customer how to un-dock the LCSS.Initial ActionsCheck the fuse on the 2K LCSS PWB, If the fuse is good, continue at the procedure. If the fusenot good, install a new 2K LCSS PWB, PL 11.26 Item 1.Check the 2K LCSS PWB DIP switch settings, refer to 11F-110 2K LCSS PWB DIP Switch Set-tings RAP.Remove the 2K LCSS covers, REP 11.1-110, so that the units can be viewed. Cheat the frontdoor interlock switch and the top cover interlock switch. Check that LED 2 is illuminated, thisshows that all interlocks are made. If the LED fails to illuminate, go to 11-300-110, 11-302-110,11-303-110 Interlocks RAP.ProcedureFigure 1, Check that the software heartbeat is present on LED 1. The LED should flash twiceper second if the 2K LCSS software is running. If necessary, re-load the 2K LCSS software,refer to GP 4 Machine Software.If the initialization sequence fails to place any unit at the home position, refer to the appropriateRAPs:• Front tamper not at home, refer to 11-005-110, 11-006-110, 11-310-110, 11-311-110 FrontTamper Move Failure RAP• Rear tamper not at home, refer to 11-007-110, 11-008-110, 11-312-110, 11-313-110, 11-319-110 Rear Tamper Move Failure RAP.• Paddle not at home, refer to 11-024-110, 11-025-110 Paddle Roll Failure RAP.• Bin 1 not at home, refer to 11-030-110, 11-334-110, 11-335-110, 11-336-110 Bin 1 Move-ment Failures RAP.• Punch not at home, refer to 11-043-110, 11-350-110 Hole Punch Operation Failure RAP• Staple head not at home, refer to 11-050-110, 11-360-110 Staple Head Operation FailureRAP.• Stapling unit not at home, refer to 11-053-110, 11-370-110 Staple Head Unit MovementFailure RAP.• Ejector not at home, refer to 11-320-110, 11-322-110 Compiler Ejector Movement FailureRAP.Figure 1 LED locationLED 2LED 1Fuse
