August 20072-306 WorkCentre 5687 Family11-100-110, 11-110-110Status Indicator RAPsFigure 2 Circuit diagram11-110-110 Sheet Late to Hole Punch RAP11-110-110 Sheet late at the punch sensor.WARNINGTake care not to topple the LCSS.The LCSS is unstable when un-docked from the machine.Do not show the customer how to un-dock the LCSS.Initial ActionsCheck the following:• The 2K LCSS PWB DIP switch settings, refer to 11F-110 2K LCSS PWB DIP Switch Set-tings RAP.• Ensure the paper tray guides are set to the correct position for the size of paper in thetray.• For a paper jam at the entrance to the 2K LCSS. Check that there is no obstruction thatwould prevent a sheet from arriving in position for punching, refer to the 11H-110 CopyDamage in the 2K LCSS RAP.• The punch sensor, Q11-110 for chad debris, Figure 1.ProcedureNOTE: In diagnostics, actuating any 2K LCSS sensor or switch can change the displayed stateon the UI. Make sure that the correct sensor or switch is tested.Figure 1. Enter dC330, code 11-110. Actuate the punch sensor, Q11-110. The displaychanges.Y NGo to Flag 1 and check Q11-110.Refer to:• 11G-110 2K LCSS PWB Damage RAP.• GP 11, How to Check a Sensor.• P/J307, 2K LCSS PWB.• 11D-110 2K LCSS Power Distribution RAPRepair or install new components as necessary:• Punch sensor, PL 11.6 Item 7.• 2K LCSS PWB, PL 11.26 Item 1.Perform SCP 6 Final Actions.
