August 20072-215WorkCentre 5687 Family 08-150B, 08-151BStatus Indicator RAPsY NGo to Flag 2. Check Q08-100. Refer to:• GP 11 How to Check a Sensor.• P/J16, IOT PWB.• 01E +5V Distribution RAP.• 01B 0V Distribution RAP.Install new components as necessary:• Wait sensor, PL 7.30 Item 25.• Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL1.10 Item 2.Enter dC330 code 04-010 main drive motor. Press Start. The motor runs.Y NGo to the 04A Main Drive Motor and Photoreceptor Motor RAP.While the motor is running, add code 08-070 registration clutch, CL08-070. Press Start.NOTE: The registration clutch will switch off after 5 seconds.Switch the registration clutch on / off up to 10 times. The jam clearance knob 4c, PL 8.17Item 10, rotates when the registration clutch is energized.Y NGo to Flag 3. Check CL08-070. Refer to:• GP 12 How to Check a Solenoid or Clutch.• P/J5, IOT PWB.• P/J17, LVPS.• Fuse, PL 1.10 Item 9, GP 7.• 01G +24V Distribution RAP.• 01B 0V Distribution RAP.Install new components as necessary:• Registration clutch, (65-87 ppm) PL 8.17 Item 7.• Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL1.10 Item 2.Perform the following:• Check the registration transport rolls and registration rolls, (65-87 ppm) PL 8.17 Item 1,GP 7.• Check the drives plate on the registration clutch for damage and contamination. Refer tothe replacement procedure in REP 8.5. If necessary, install a new registration clutch, PL8.17 Item 7.• Check the tray 1 and 2 transport motor, PL 8.25 Item 5. Ensure that the motor runs cor-rectly.• Check the tray 1 and 2 transport roll assemblies, transport drive belt and pulleys, PL 8.26Item 1, GP 7. Install new components as necessary.• Install a new tray 1 and 2 control PWB, PL 7.10 Item 2.Figure 1 Component locationRegistration sensorQ08-150Wait sensorQ08-100Registration niprollsRegistration clutchCL08-070Registration transportrollsLeft hand door
