User Manual UMN:CLIV810287113.8.7.4 RTP Synchronization SourceTo configure the RTP synchronization source, use the following command.Command Mode Descriptionrtp-sync-source payload VALUEsignalling VALUETDM-PW-ProfileSpecifies the RTP synchronization source in the TDMto PSN direction.payload VALUE: for the payload channelsignalling VALUE: for the optional separate signallingchannel. If signalling is not transported in its own chan-nel, this value should be set to 0.rtp-expect-sync-source payloadVALUE signalling VALUESpecifies the RTP synchronization source in the PSNto TDM direction. The received synchronization sourcemay be used to detect misconnection (stray packets).payload VALUE: for the payload channelsignalling VALUE: for the optional separate signallingchannelno rtp-expect-sync-source Deletes the configured RTP synchronization source inthe PSN to TDM direction.13.8.8 Pseudowire Maintenance ConfigurationIf you need the configuration for pseudowire service exception handling, you should con-nect a pseudowire maintenance profile to the current profile.To connect the pseudowire maintenance profile to the current profile, use the followingcommand.Command Mode Descriptionpw-maintenance-profile NAME TDM-PW-ProfileConnects a pseudowire maintenance profile to thecurrent TDM pseudowire profile.no pw-maintenance-profile Disconnects the specified pseudowire maintenanceprofile.For the details of how to create and configure the pseudowire maintenance profile, see13.9 Pseudowire Maintenance Profile.13.8.9 Saving TDM Pseudowire ProfileAfter configuring a TDM pseudowire profile, you need to save the profile with the followingcommand.Command Mode Descriptionapply TDM-PW-Profile Saves a TDM pseudowire profile configuration.Whenever you modify a TDM pseudowire profile, you should apply the changes again us-ing the apply command. If not, the changes will not be applied.ii
