UMN:CLI User ManualV810256411.2.3.7 Displaying MLD Snooping InformationTo display the MLD snooping table, use the following command.Command Mode Descriptionshow ipv6 mld snooping groupsEnableGlobalShows a group membership information for MLDsnooping.X:X::X:X: IPv6 multicast group addressIFNAME: interface nameshow ipv6 mld snooping groups{detail | X:X::X:X detail}show ipv6 mld-proxy groups{tengigabitethernet IFPOR |gpon IFPORT | channelgroupIFPORT | vlan VLANID} [detail]show ipv6 mld-proxy groups{tengigabitethernet IFPOR |gpon IFPORT | channelgroupIFPORT | vlan VLANID} [X:X::X:Xdetail]show ipv6 mld snooping inter-faceShows the interface information for MLD snooping.show ipv6 mld snooping inter-face {tengigabitethernet IFPOR |gpon IFPORT | channelgroupIFPORT | vlan VLANID}show ipv6 mld snooping mrout-er {tengigabitethernet IFPOR |gpon IFPORT | channelgroupIFPORT | vlan VLANID}Shows a current multicast router port for MLD snoopingshow ipv6 mld snooping stats{tengigabitethernet IFPOR |gpon IFPORT | channelgroupIFPORT}Shows the statistics information for MLD snooping.To delete the MLD snooping statistics from the MLD table, use the following command.Command Mode Descriptionclear ipv6 mld snooping stats{tengigabitethernet IFPOR |gpon IFPORT | channelgroupIFPORT}EnableGlobal Deletes MLD snooping statistics.11.2.4 MLD State LimitYou can use MLD State Limit feature to limit the number of MLD states that can be joinedto a router on a per-interface or global level. The MLD group limits feature provides pro-tection against DoS (denial of service) attacks caused by MLD packets. Membership re-ports exceeding the configured limits are not entered into the MLD cache and traffic forthe excess membership reports is not forwarded.
