UMN:CLI User ManualV8102270fault: 3 seconds)To the configured interval of ARP request messages, use the following command.Command Mode Descriptionno ip arp-request interval mc_probeInterface[VLAN]Deletes the configured interval of ARP request mes-sage.no ip arp-request interval retransno ip arp-request interval uc_probe8.1.3 ARP AliasAlthough clients are joined in the same client switch, it may be impossible to communi-cate between them for security reasons. When you need to make them communicateeach other, the V8102 supports ARP alias, which responses the ARP request from clientnet through the concentrating switch.To register the address of client net range in ARP alias, use the following command.Command Mode Descriptionarp alias A.B.C.D A.B.C.D[XX:XX:XX:XX:XX:XX]GlobalRegisters the IP address range and MAC address inARP alias to make the system response to an ARPrequest.arp alias A.B.C.D A.B.C.D vlanVLAN gateway GATEWAYRegisters gateway IP address within IP address rangeto make the system response automatically MAC ad-dress of gateway.VLAN: 1-4094GATEWAY: gateway IP addressno arp alias A.B.C.D A.B.C.D Deletes the registered IP address range of ARP alias.To register the MAC address of client in ARP alias per VLAN interface, use the followingcommand.Command Mode Descriptionip arp alias [XX:XX:XX:XX:XX:XX] Interface[VLAN]Registers a MAC address in ARP alias to make theVLAN response to an ARP request.no ip arp alias Deletes the registered MAC address of ARP alias.Unless you input a MAC address, the MAC address of user’s device will be used for ARPresponse.To set aging time of gateway IP address in ARP alias, use the following command.Command Mode Descriptionarp alias aging-time<5-2147483647> GlobalSets the aging time of gateway IP address.5-2147483647: aging time (default: 300 seconds)no arp alias aging-time Deletes the aging time of gateway IP address.i
