UMN:CLI User ManualV8102644 System Basic Configuration and Operation4.1 Basic ConfigurationAfter installing the system, the V8102 is supposed to examine that each port is correctlyconnected to network and management PC. You can connect to the system to configureand manage the V8102. This section provides instructions how to change password forsystem connection and how to connect to the system through telnet.4.1.1 Connecting to the Console PortTo begin setup, you must connect the Console to the RJ45 Console port. To connect thecable, perform the following steps:Step 1 Attach the RJ45 connector on the cable to the RJ45 connector on the console port of theV8102.Step2 Connect the other end of the cable to one of the serial ports on your workstation.Step3 Open your terminal emulation software and configure the COM port settings to which youhave connected the cable. The settings should be set to match the default settings for theswitch, which are:• 9600 bps• 8 data bits• 1 stop bit• No parity• No flow control4.1.2 System LoginAfter installing the V8102, finally make sure that each port is correctly connected to PCfor network and management. Then, turn on the power and boot the system as follows.Step 1 When you turn on the switch, booting will be automatically started and login prompt willbe displayed.SWITCH login:Step 2 When you enter a login ID at the login prompt, the password prompt will be displayed,and then enter the proper password to log in the system. By default setting, the login ID isconfigured as admin with no password.SWITCH login: adminPassword:SWITCH>Step 3 In Privileged EXEC View mode, you can check only the configuration for the switch. Toconfigure and manage the switch, you should begin Privileged EXEC Enable mode. Thefollowing is an example of beginning Privileged EXEC Enable mode.SWITCH> enableSWITCH#
