UMN:CLI User ManualV8102622Command Mode Descriptionneighbor {A.B.C.D | X:X::X:X |WORD} activate RouterRouter AFActivates neighbors.A.B.C.D: BGP neighbor IP addressX:X::X:X: BGP neighbor IPv6 addressWORD: BGP peer groupno neighbor {A.B.C.D | X:X::X:X |WORD} activate Disables exchange of information with a neighbor.For information about how to create peer groups, refer to the neighbor peer-group andneighbor remote-as commands.12.1.17.10 Neighbor Advertisement IntervalTo reduce the flapping of routes to internet, a minimum advertisement interval is set, sothat the BGP routing updates are sent only per interval seconds. BGP dampening can al-so be used to control the effects of flapping routes.To set a minimum interval between the sending of BGP routing updates, use the followingcommand.Command Mode Descriptionneighbor {A.B.C.D | X:X::X:X |WORD} advertisement-interval<0-600> RouterSets a minimum interval between the sending of BGProuting updates.A.B.C.D: BGP neighbor IP addressX:X::X:X: BGP neighbor IPv6 addressWORD: BGP peer group0-600: advertisement value in secondesno neighbor {A.B.C.D | X:X::X:X |WORD} advertisement-interval[<0-600>]Sets the interval time to default.For information about how to create peer groups, refer to the neighbor peer-group andneighbor remote-as commands.12.1.17.11 Neighbor Allowas-inTo advertise prefixes (routes) even when the source of the prefixes is from the same Au-tonomous System (AS) number, use the following command.Command Mode Descriptionneighbor {A.B.C.D | X:X::X:X |WORD} allowas-in <1-10> RouterSets a minimum interval between the sending of BGProuting updates.A.B.C.D: BGP neighbor IP addressX:X::X:X: BGP neighbor IPv6 addressWORD: BGP peer group1-10: number of times to allow the advertisement of anAS number.ii
