UMN:CLI User ManualV8102134SWITCH(config)#6.2.8 System Memory InformationTo display a system memory status, use the following command.Command Mode Descriptionshow memory [all]EnableGlobalShows system memory information.show memory {bgp | dhcp | eqm| free | gpon | hwmon | imi | ipv6| lib | nsm | ospf | pim | pim6 |pppoe | recp | rip | sfpmon |summary | swch}Shows system memory information with a specificoption.To configure a debugging for dynamic memory trace, use the following command.Command Mode Descriptiondebug memory mtrace DAEMON{start | end}EnableEnables/disables the debugging for dynamic memorytrace of the specified daemon.DAEMON: daemon nameshow debug memory mallinfoDAEMONDisplays the debugging of dynamic memory allocationinformation.6.2.9 CPU Packet LimitIf the CPU of the system processes too many packets during the operation, it may causethe performance decrease. To prevent the CPU overload, you can manually limit thenumber of the packets handled by CPU.To limit the number of the packets handled by CPU, use the following command.Command Mode Descriptioncpu packet limit <100-20000>GlobalLimits the number of the packets handled by CPU.100-20000: incoming packets per second to CPU (de-fulat : 3500)cpu packet limit <0-7> <100-20000>Limits the number of the packets handled by CPU.0-7 : Queue number100-20000: incoming packets per second to CPU (de-fulat : unlimited)no cpu packet limit [<0-7>] Deletes the configured numbers of incoming packetsper second to CPU.To display the configured CPU packet limit, use the following command.Command Mode Descriptionshow cpu packet limit EnableGlobal Shows the configured CPU packet limit.
