5-95 SENDING DOCUMENTSRedialling when the line is busyThere are two methods of redialling: manual redialling and automatic redialling. This section explains thesetwo methods.Manual redialling ___________________________Press [Redial/Pause] to dial the last number you dialled with the numeric buttons. (This starts rediallingregardless of whether automatic redialling is enabled.)K Cancelling manual rediallingTo cancel manual redialling, press [Stop].Automatic redialling _________________________K What is automatic redialling?When you are sending a document and the receiving party’s line is busy, the fax waits the specified timeand then dials the same number again. You can set the fax to redial several times if previous attempts failbecause of a busy signal.Automatic redialling can be turned off and on. The number of redialling attempts and the time intervalbetween attempts can also be adjusted (see AUTO REDIAL, p. 8-3).If all redialling attempts are unsuccessful, the fax will cancel the transmission and print an ERROR TXREPORT to remind you that the transmission was not completed (see p. 8-7).When automatic redialling is in use, the LCD displays AUTO REDIAL while it is waiting to redial.K Cancelling automatic rediallingAutomatic redialling cannot be cancelled with the [Stop] button while the fax is waiting to redial.1 Wait until the fax begins redialling.2 Press [Stop].NoteIf you want to cancel a memory-sending transmission while the fax is waiting to redial, you will haveto delete the document from memory (see p. 5-15).
