Canon B115 User Manual

Contents

Canon B115 User Manual Manual pdf 102 page image

1-71 SETTING UPLoading paperPaper guidelines ___________________________• Be sure to load paper of the correct size, weight, and quantity recommended for your fax (see pp. 3-1, S-1).• Store all paper wrapped and on a flat surface until ready to use. Keep opened packs in their originalpackaging, in a cool, dry location.• Store paper at 18°-24°C, 40%-60% relative humidity.• To avoid paper jams and poor print quality, do not print on damp, curled, wrinkled, or torn paper.• Use cut-sheet paper only, not paper that comes on a roll.• Use only paper that has a thickness of between 0.08 and 0.13 mm. Thick paper may damage the BJcartridge print head.• Do not load paper beyond the paper limit mark (P) or beyond the tab on the paper guide. Doing so maycause problems. Also, make sure there are no gaps on either side of the paper stack.• Let the paper run out before refilling the multi-purpose tray. Avoid mixing new stock with paper alreadyloaded.• Do not leave paper stacked in the multi-purpose tray for long periods of time since it may bend or curl andcause problems.• Certain environmental conditions, such as extreme temperatures or humidity, can cause some paper tomisfeed in the multi-purpose tray. If you have trouble, feed one sheet at a time.• Depending on the density of the printed pages, the ink may need time to dry. Within two or three seconds,the ink becomes smudge-resistant. After drying for several minutes, the ink becomes water-resistant.• If your printed page contains a large amount of graphics, the ink on the page may be damp due to the printdensity. Leave the page for 30 to 60 seconds to allow the ink to dry. Then remove the page carefullywithout touching any surfaces.• If paper curls after printing, remove it immediately; otherwise paper jams may occur.• The platen (a roller inside the fax) may become inked if you print data beyond the width of the page. Ifthis happens, clean inside the fax (see p. 9-3).Paper limit markTabNo gaps here