Canon B115 User Manual

Contents

Canon B115 User Manual Manual pdf 53 page image

7-10Using remote control1 Call home.2 The outgoing message will be played.3 Press [#] while the outgoing message is playing.Enter your password when you hear the beepsindicating that you should enter your password.When your password is accepted, you will hear aconfirmation tone (a short series of beeps).4 The fax will now accept remote control commands(see List of remote control commands, p. 7-11).For example, press [1][1][#] to play back any telephonemessages you may have received. When playback hasfinished, press [9][9][#] to end the remote control.5 End the remote control and hang up the handset.Note• A password is required to use the remote control features. However, if PIN ENTRY is set to OFF(see p. 8-6), it is not necessary to enter your password when you use the FORWARDING MSGfeature (see p. 7-12).• If you enter an invalid password, you will hear an error tone. If you enter two invalid passwordsconsecutively, the call will be disconnected.• You should enter a remote command within 20 seconds of entering your password. If more than20 seconds elapse after you enter your password and you do not enter a remote command, the callwill be disconnected.• The remote control features can be used even when the fax is set to a mode other than TAMMODE.• In FAX ONLY MODE, the outgoing message will not be played. Press [#] when the call isconnected.• In Fax/Tel mode (FAX/TEL AUTO SW), press [#] while the Fax/Tel message is playing. If youhave not set a Fax/Tel message, press [#] when the call is connected.• In MANUAL MODE, press [#] if MAN/AUTO SWITCH has been set. If MAN/AUTO SWITCHis off, the fax will ring 15 times. Press [#] while the outgoing message is playing. Then, enter yourpassword when you hear the beeps.