2-25Phaser 3635MFP 08-100, 08-200Status Indicator RAPsDraft 408-100 Jam 1 RAP08-100 The lead edge of the document failed to actuate the fuser exit sensor within the correcttime after registration.ProcedureWARNINGSwitch off the electricity to the machine. Disconnect the power cord from the customersupply while performing tasks that do not need electricity. Electricity can cause death orinjury. Moving parts can cause injury.WARNINGDo not touch the fuser while it is hot.NOTE: The front cover assembly interlock switch must be closed to supply +24V to the motorsand clutches.Refer to Wiring Diagram 2, Wiring Diagram 8 and Wiring Diagram 9. Perform the following:1. Switch off the machine, then switch on the machine.2. Open the front cover assembly, PL 28.10 Item 7. Remove all jammed paper.3. Remove the print cartridge, PL 9.10 Item 1 and the fuser module, PL 10.10 Item 1. Checkthe paper path for damage or obstructions.4. Open the fuser door, PL 10.12 Item 19. Check the following, install new components asnecessary:a. The fuser exit sensor actuator, PL 10.12 Item 9 moves freely and is not damaged.b. The fuser heat roll, PL 10.15 Item 1, pressure roll 1, PL 10.15 Item 2 and pressureroll 2, PL 10.15 Item 3 are clean and rotate freely.c. The fuser exit roll, PL 10.12 Item 6 and idlers, PL 10.12 Item 17 are clean and rotatefreely.d. The fuser stripper fingers, PL 10.12 Item 13.5. Enter dC330 code 08-600. Check the fuser exit sensor (Q08-600). If necessary, install anew HVPS, PL 1.10 Item 3.NOTE: The fuser exit sensor is mounted on the HVPS.6. Reinstall the fuser. Enter dC330 code 04-200. Check that the exit motor (MOT04-200), PL10.20 Item 4, runs and drives the fuser rolls.7. Check the wiring between the exit motor and CN2 on the Connection PWB. Install newcomponents as necessary, PL 10.20.8. Enter dC330 code 04-100 to run the main BLDC motor.9. Check the wiring between the main BLDC motor and CN38 on the Main PWB.10. If necessary:a. Install a new print cartridge, PL 9.10 Item 1.b. Perform OF7 Main PWB Check RAP.08-200 Jam in Tray RAP08-200 The machine has detected a paper jam in the tray 2 feed area.ProcedureGo to the 07-230 Jam 0 from Tray 2 RAP.
