2-17Phaser 3635MFP 05-900, 05-920Status Indicator RAPsDraft 405-900 DADF Jam 0 RAP05-900 The lead edge of the document failed to actuate the registration sensor within the cor-rect time.ProcedureWARNINGSwitch off the electricity to the machine. Disconnect the power cord from the customersupply while performing tasks that do not need electricity. Electricity can cause death orinjury. Moving parts can cause injury.NOTE: The door open switch must be actuated to supply +24V to the motors and clutches.Refer to Wiring Diagram 10. Perform the following:1. Open the DADF door assembly, PL 5.10 Item 3. Remove all jammed paper.2. Check the document path for damage or obstructions.3. Check the pickup roll assembly, PL 5.25 Item 2. If necessary, install a new pickup rollassembly, PL 5.25 Item 2.4. Check the retard pad assembly, PL 5.30 Item 2. If necessary, install a new retard padassembly, PL 5.30 Item 2.5. Check that the registration sensor actuator, PL 5.35 Item 10 moves freely and is not dam-aged.6. Enter dC330 code 05-130. Check the registration sensor (Q05-130), PL 5.35 Item 7.7. Check the wiring between the registration sensor and CN1 on the DADF PWB. If neces-sary, install a new registration sensor, PL 5.35 Item 7.8. Enter dC330 code 05-201. Check that the DADF scan motor (MOT05-200), PL 5.40 Item2 runs.9. Check the wiring between the DADF scan motor and CN9 on the DADF PWB. If neces-sary, install a new DADF scan motor, PL 5.40 Item 2.10. While the DADF scan motor runs, stack the code 05-300 to energize the pick up solenoid(SOL05-300). Check that the pickup roll, PL 5.25 Item 2 rotates.11. Check the wiring between the pick up solenoid and CN7 on the DADF PWB. If necessary,install a new pick up solenoid, PL 5.40 Item 3.12. If necessary, install new components:• DADF PWB, PL 5.15 Item 16.• DADF drive assembly, PL 5.40 Item 1.• Document transport assembly, PL 5.35 Item 14.05-920 DADF Door Open RAP05-920 The machine has detected that the DADF door is open.ProcedureWARNINGSwitch off the electricity to the machine. Disconnect the power cord from the customersupply while performing tasks that do not need electricity. Electricity can cause death orinjury. Moving parts can cause injury.Refer to Wiring Diagram 10. Perform the following:1. Open the DADF door assembly, PL 5.10 Item 3. Check that the DADF door open sensoractuator is not missing or damaged. If necessary, install a new DADF door assembly, PL5.10 Item 3.2. Enter dC330 code 05-160. Check the DADF door open sensor (Q05-160), PL 5.40 Item13.3. Check the wiring between the DADF door open sensor and CN5 on the DADF PWB. Ifnecessary, install a new DADF door open sensor, PL 5.40 Item 13.4. If necessary, install a new DADF PWB, PL 5.15 Item 16.
