4-50 Phaser 3635MFPADJ 8.1, ADJ 8.2Draft 4Repairs and Adjustments6. Select Read/Write. Enter a new value as follows:• To increase the lead edge registration (move the ABC line away from the paperedge), enter a value larger than the current value.• To decrease the lead edge registration (move the ABC line toward the paper edge),enter a value smaller than the current value.NOTE: A change of 12 will change the registration by approximately 1mm (0.04inch)7. Save the adjustment.a. Select Save.b. Select OK.8. Prepare to check the adjustment.a. Select Close.b. Select Diagnostic Routines.c. Select Other Routines.9. Perform again the Check.ADJ 8.2 Side Edge Registration AdjustmentPurposeTo measure and adjust side edge image to paper registration.CheckNOTE: Both the Check and the Adjustment use an internal test pattern. Both are performed indiagnostics.Check the side edge registration (left side edge of portrait A4 or 8.5x11 inch). Perform the fol-lowing:1. Enter dC606 Internal Print Test Patterns.2. Select test pattern 7.3. Select Features. For simplex side edge check, select 1 Sided. For duplex side edgecheck select, 2 Sided.4. Select the tray. Select Start Test.NOTE: Simplex copies exit face down. Duplex copies exit side 1 face down (side 2 faceup).Duplex Side 1 Bypass 07-520Duplex Side 2 1 07-120Duplex Side 2 2 07-220Table 1 NVM locationMode Tray Location
