Toshiba TOSVERT VFS15-2004PM-W1 Instruction Manual

Also see for TOSVERT VF-S15 series: Function manual Quick start manual Instruction manual Instruction manual Instruction manual

E6581611H-98Note 6: Overload characteristic of inverter and region setting are displayed on the monitor as follows;c-xx : aul=1 (Constant torque characteristic) is selected.v-xx : aul=2 (Variable torque characteristic) is selected.x-eu : Setup menu is selected to eu.x-as : Setup menu is selected to asia.x-us : Setup menu is selected to usa.x-jp : Setup menu is selected to jp.Note 7: Past trip records are displayed in the following sequence: 1 (latest trip record) 2345678(oldest trip record). If no trip occurred in the past, the message “” will be displayed. Details onpast trip record 1 to 8 can be displayed by pressing the center of the setting dial when past trip 1 to 8 isdisplayed. Refer to section 8.2.2 for details.Note 8: Parts replacement alarm is displayed based on the value calculated from the annual average ambienttemperature specified using , the ON time of the inverter, the operating time of the motor and theoutput current (load factor). Use this alarm as a guide only, since it is based on a rough estimation.Note 9: The cumulative operation time increments only when the machine is in operation.Note 10: If there is no trip record, nerr is displayed.Note 11: Of the items displayed on the monitor, the reference values of items expressed in percent are listed below. Output current: The current monitored is displayed in percentage. The value indicated on thenameplate is 100%. The unit can be switched to A (amperes). Input voltage: The voltage displayed is the voltage determined by converting the voltagemeasured in the DC section into an AC voltage. The reference value (100%value) is 200V (240V class), 400V (500V class). The unit can be switched to V(volts). Output voltage: The voltage displayed is the output command voltage. The reference value(100% value) is 200V (240V class), 400V (500V class). This unit can beswitched to V (volts). Load factor of inverter: Depending on the PWM carrier frequency (f300) setting and so on, theactual rated current may become smaller than the rated output currentindicated on the nameplate. With the actual rated current at that time (after areduction) as 100%, the proportion of the load current to the rated current isindicated in percent. The load factor is also used to calculate the conditionsfor overload trip ().Note 12: Status monitor of * mark is displayed by  to  and  setting. The left sidecharacter is as following table by each parameter setting number.