Toshiba TOSVERT VFS15-2004PM-W1 Instruction Manual

Also see for TOSVERT VF-S15 series: Function manual Quick start manual Instruction manual Instruction manual Instruction manual

E6581611F-1266.2 Selection of operation mode6.2.1 Selection of start/stop and frequency settings : Command mode selection : Frequency setting mode selection FunctionThese parameters are used to specify which input device (panel keypad, terminal block, orcommunication) takes priority in entering an operation stop command or frequency setting mode (terminalVIA/VIB/VIC, setting dial, communication, or UP/DOWN from external logic).[Parameter setting]Title Function Adjustment range Default setting Command mode selection0: Terminal block1: Panel keypad (including extension panel)2: RS485 communication3: CANopen communication4: Communication option1[Programmed value]: Terminal blockoperation ON and OFF of an external signal run and stop operation.: Panel keypadoperationPress the and keys on the panel keypad to run and stop.Operation can also be done from the extension panel.: RS485communicationRun/stop operations by RS485 communication from an external device.⇒ Refer to section 6.33.3: CANopencommunicationRun/stop operations by CANopen communication from an external device.⇒ Refer to “CANopen communication Instruction Manual E6581911”.4: CommunicationoptionRun/stop operations by commands from a communication option.⇒ Refer to each Instruction Manual of option.* Operation command selected by  and the operation commands from the terminal block can beswitched alternately with ON/ OFF of input terminal. (input terminal function number 108, 109) See the table ofinput terminal function selection in section 11.6.* When priority is given to commands from a linked computer or terminal block, they have priority over thesetting of .STOPRUN