Honeywell Galaxy Flex Installer Manual

Also see for Galaxy Flex: User guide

Contents

Honeywell Galaxy Flex Installer Manual Manual pdf 42 page image

System [23] Galaxy Flex Installer Manual42When you access the event log, the most recent event is displayed. Use A or B to scrollthrough the events. Hold down either key to scroll quickly through the dates.The event log is wrapped round from beginning to end. The message START or END isbriefly displayed when the wrap-around is passed through.The following information is detailed in the event log: Time of event. Date the event occurred. Event - information about the type of event that occurred. Certain events are displayedwith a + (indicating that the event started or was activated) or – (indicating that theevent ended or was terminated) symbol. User - alternates between the name and number of the user who initiated the event. Ifthe event is not associated with a user code, for example, an alarm activation or a finalzone closing, then no user information is displayed.Press # while viewing the log to see additional information about certain event types: User events reveal the keypad, user type and user group involved in the event. Alarm events reveal the zone descriptor, if programmed. Walk tested RF zones reveal the measured signal strength of each RF device. REM CALL event displays the Remote Station ID for the Remote Servicing Softwarewhich has made the connection with the panel.Notes:1. Where two identical events occur within 1 second, only one is logged.2. Only the first occurrences of high resistance and low resistance events on each day arelogged. Subsequent activations are ignored until midnight of the same day. This is toprevent the log from being filled with high and low resistance activations from a faultyzone.You can print the event log while accessing the Display Log option. Press whiledisplaying an event to start the printout. All events from the displayed event to the mostrecent event are printed. If required, press esc to abort a print out.Note: A printer must be connected to the panel via a printer interface module.System [23]Use this option to display an overview of the system configuration. You can scroll throughthe items shown below, which are displayed using both lines on the keypad screen.10:24 SUN 01 JANK10 L7K = keypaduser type (user level)keypad addressAB line