Honeywell Galaxy Flex Installer Manual

Also see for Galaxy Flex: User guide

Contents

Honeywell Galaxy Flex Installer Manual Manual pdf 162 page image

Options [63] Galaxy Flex Installer Manual162Options [63]Use this function to divide the system into group subsystems.Options Menu63 = Options 1 = Groups 1 = Group Mode 0 = Disabled 1 = Enabled 2 = Setting Logic - = Status of group unimportant S = Group must be set to allow group to set 3 = Group Name A/B to move to group and entententent to select# = toggle upper case, lower case or library text = delete last characterA/B = move to character/wordent = assign character/wordesc = save programming.Group Mode [63.1.1]Use this option to enable the Groups function (default is 0=Disabled). When enabled, thesystem options that are eligible for group programming are then made available throughoutthe menu, otherwise they do not appear.To enable Groups:1. Select the Group Mode enable option, and then press ent to accept the programming.2. Return to the Engineer Mode banner to enable groups completely.To disable Groups:1. Select the Group Mode disable option, and then do one of the following: Press 1 (Reset Groups), and then press ent.All group programming for all the panel features is reset to A1. The messageATT!!! GRPS OFF, SYS. OP. IMPACT is displayed on exit from engineeringmode, warning that groups have been reset and there will be an impact on theoperation of all functions not programmed as group A1.Note: When group programming is re-enabled all previous group programming isnot restored. Press 2 (Disabled), and then press ent.All group programming other than A1 is disabled (zones, outputs, links, and users).The message ATT!!! GRPS OFF, SYS. OP. IMPACT is displayed on exit fromengineering mode, warning that groups have been disabled and there will be animpact on the operation of all areas not programmed as group A1.