Honeywell Galaxy Flex Installer Manual

Also see for Galaxy Flex: User guide

Contents

Honeywell Galaxy Flex Installer Manual Manual pdf 31 page image

Galaxy Flex Installer Manual Set using a PIN31Section 4: System programmingSetting OptionsSet using a PINTo Full Set:1. Type your user code.2. Press A.If groups are enabled and your user code has been assigned group choice, the keypaddisplays the set status of the available groups as follows:R = ReadyF = Fault (group is unset and at least 1 zone is open)S (flashing) = selected for settingS (steady) = already set− = Group is not available to the userPressing a group number toggles the R (ready) to an S (set flashing).If groups are not enabled or your user code does not have group choice, the settingprocedure starts immediately.The exit time countdown is displayed. At the end of the exit time or when the settingprocedure is terminated by a final or push-set zone closing, the entry/exit horn and keypadbuzzers become silent for four seconds, then emit two long tones to confirm that the systemis set. The message SYSTEM SET appears briefly before the keypad display changes backto the normal day banner.TIMED 060■■■■■■■■□□□□□□□□SET A12345678Groups RRSRSSSSSET A12345678Groups SSSRR---