Galaxy Flex Installer Manual Menu access27Section 3: Menu structureYou can control and setup the Flex system via these two menu structures: Full menu – accessible only by authorized users including the master manager and theengineer. The full menu has a hierarchy of five levels that allow users with the rightauthority to perform increasingly advanced setup procedures. Quick menu – provides up to ten options from the full menu. The quick menu is thedefault menu for all user codes (type 3 and above), except master manager andengineer.Menu accessOnly valid codes (type 3 and above) can access the menus. Access to the user options isassigned by the engineer (refer to options Codes [42] and Menu Access [68]). Users cannotview or access options for which they are not authorized. This includes options in the QuickMenu.Note: Menu options 51 to 72 (Engineer 1, Engineer 2 and Engineer 3) can be assignedadditional access to user type 3 to 6, by the engineer.To access the menus:1. On a keypad, enter your user code.2. Press ent.You will now have access to one of the menu structures outlined below. If you are using anengineer code see Engineer Mode on page 29.Quick menuThe default quick menu options are shown on the right.You can modify the options available on the quick menuusing the 59=QUICK MENU option.On entering the menu the first option in the list isdisplayed on the keypad:0 = Omit Zones1 = Chime2 = Display Zones3 = Display Log4 = Print5 = Walk Test6 = Time/Date7 = Codes8 = Summer9 = Eng. AccessPress A or B to scroll to another option, or press thenumber key of the option you want.To select an option, press ent.0=OMIT ZONES[ent] to Select
