Honeywell Galaxy Flex Installer Manual

Also see for Galaxy Flex: User guide

Contents

Honeywell Galaxy Flex Installer Manual Manual pdf 39 page image

Galaxy Flex Installer Manual Part Set [13]39Note: The factory default setting allows the timed setting routine to be initiated by enteringa valid type 1 user code (or above) and then pressing A. By default the A key isassigned to the Timed Set function. The A key can be reprogrammed by the engineerto perform another function, or to start the setting routine without a code beingentered.Part Set [13]This option operates exactly as the Timed Set option with the exception that only thosezones that have the part attribute enabled are set (refer to Program Zones [52]). All zoneshave the part attribute enabled by default. Therefore selecting Part Set from the factory willset all zones. To exclude zones from the part set, disable the Part attribute.Note: The factory default setting allows the part setting routine to be initiated by entering avalid type 1 (or above) user code and pressing B. By default the B key is assigned tothe Part Set function. The B key can be reprogrammed by the engineer to performanother function, or to start the part setting routine without a code being entered.Forced Set [14]Option not available.Chime [15, Quick Menu 1]The Chime option allows the user to switch the chime facility on and off. Any zones thathave the chime attribute enabled (refer to Program Zones [52]) momentarily operateentry/exit horns when opened, and two long tones are emitted.Instant Set [16]Selecting this option immediately sets all zones. There is no sounder or exit time.Note: Zones must be closed to allow the system to set. If any zones are open the exit timereset feature (detailed previously) is activated.Silent Part [17]Selecting this option sets all zones that have the part attribute enabled. It starts a normaltimed exit procedure but exit sounders are not activated. In the event of an alarm occurringduring a Silent Part set (e.g. fire alarm), normal operation will be re-instated.When group mode is enabled (option [63.1]), no other group setting options are affected.Note: Zones must be closed to allow the system to silent set. If any zones are open, thenthe Exit Time Reset feature (detailed previously) is activated.Unsetting results in a double beep.